6 element 18MHz LFA Yagi (17.7m)

A 6 element High Performance LFA Yagi

The G0KSC LFA Yagi is a major step forward in the development of the Yagi Antenna, it provides a low-noise front-end for your radio so you hear more weak signals while at the same time maximising all round performance. This 6 element 18Mhz LFA provides stunning performance across the whole 17m band (18.06 - 18.200MHz). Hard to beat with a direct 50 Ohm feed-point and no matching losses and suppression of unwanted noise!! More 

NOTE: With all our HF antennas we can custom design your element taper and element size requirements in order to cater for all weather and installation requirements 

Performance

Gain: 11.36dBi @ 18.110MHz

F/B: 29.29dB @ 18.110MHz

Peak Gain: 11.42dBi

Gain at 17m above Ground: 16.31dBi @ 18.110MHz

Peak F/B: 30.46dB

Power Rating: 5kw

SWR: Below 1.1.1 from 18.060 - 18.170MHz

Boom Length: 17.7m

Stacking Distance: 12 -15m (13.5m recommended)

2 Stacked Gain @ 13.5m spacing: 14.05dBi

2 Stacked F/B: 25.98dB

2 Stacked Gain @ 13.5m Spacing 17m above ground: 18.64dBi

Weight: 52.24Kg / 115LB

Turning Radius: 9.837m / 32.27ft

Wind Loading: 1.36 Square Metres / 14.6 Square feet

Wind Survival: 161KPH / 100MPH - A 125MPH (HD) version is available upon request

Other options available if higher wind loading/survival is required.

Specification

This antenna is made with elements that taper from 1 inch (25.4mm) to 7/8 inch (22.23mm) then 3/4 inch (19.05mm) to 5/8 inch (15.88mm) to 1/2 inch (12.7mm) and 3/8 inch (9.525mm) outer elements. The antenna has fully insulated elements which will ensure continuous, high performance for many years to come. Boom to mast brackets are included with all antennas which will support 2 inch (50mm) masts.  Boom is 3 inch square (76.2mm)  10SWG (3.2mm) aluminum.

Our antennas are constructed with the best quality materials in order that the best mechanical construction can be achieved, not the cheapest and most profitable! Even a digital caliper is used (with an accuracy of .01mm) to measure the elements during production to ensure they are within 0.2mm of what they should be, ensuring they work as well as our software model predicts (VHF).

Note: Much development time has gone into our antennas, not just on basic electromagnetic design, we are able to model the effect of insulators, booms and other objects to ensure the make up of our antennas have least effect on performance and pattern degradation. More information can be found here

• Marine grade Stainless Steel Fittings*
• Original Stauff Insulation clamps
• Mill finished boom and elements for highest levels of accuracy

Azimuth Plot

Elevation Plot

Single 6 element LFA up 17m above ground

2 x 6 el LFA Yagi 13.5m apart with the bottom antenna 17m above ground

SWR

Manufactured the right way, not the cheapest way! 

*Where possible marine grade stainless steel is used.